Application Case2026-11-17

How to Select an HPMC Grade: Reading the Viscosity Table Against Your Application

Sixteen WoodCelo HPMC grades differ mainly in viscosity. Here is how to read the grade table, map viscosity to application, and pick the right grade for adhesives, plasters, grouts and self-levelling compounds.

How to Select an HPMC Grade: Reading the Viscosity Table Against Your Application

Hydroxypropyl methylcellulose is used across construction chemistry as a thickener, a water retention agent and a film former. Our WoodCelo range covers sixteen grades, and the difference between them is overwhelmingly one property: viscosity. Once viscosity is understood, grade selection becomes a short calculation rather than a trial and error exercise.

The property that separates the grades

Viscosity is measured on a prepared aqueous solution, and the concentration of that solution matters as much as the number itself. The WoodCelo grade table quotes Brookfield viscosity for the low-viscosity grades at a 2% aqueous solution and for the high-viscosity grades at a 1% aqueous solution, so the two groups are not directly comparable without converting to a common basis.

The grades run from a nominal 400 mPa·s at 2% through 4,000, 15,000, 50,000 and 100,000 mPa·s, into the S-series at 150,000 and 200,000 mPa·s, with the G-200K and H200K grades at the top of the range. Two grade families differ in substitution: the S grades are surface-treated for better dispersibility in cold water.

The specification shared by every grade

Apart from viscosity, the grades share one specification. Hydroxypropyl degree of substitution 0.1 to 0.3, methoxy degree of substitution 1.1 to 1.6, gel temperature 68 to 80 °C, pH 5 to 8, moisture 5% maximum, ash 5% maximum, and particle size 90% through 250 µm. Appearance is white or off-white powder.

Mapping viscosity to application

Our recommendation chart maps application to grade. For cement-based tile adhesives the chart lists the H020, H040, H060, H080, H100 and H150 series with their surface-treated counterparts, with dispersion-based tile adhesives and plaster board tile adhesives taking narrower selections. Cement-based plasters take the same broad range from H020 through H200, while machinery plasters take the lower H020 and H040 grades and manual plasters take H080 and H100.

Finishing plasters and waterproof putty or skim coat take H080 through H200, and gypsum-based plasters take H040 through H100. Cement-based tile grouts take the H020 and H040 grades and joint fillers take H004 and H040. Self-levelling compounds take the H400S and H004S grades, interface agents take H080, H100 and H200, stone paint takes H040, H060 and H100, and detergents take the H150S and H200S grades.

How to use this in a formulation

The rule of thumb is that water retention and thickening rise with viscosity, and that a higher viscosity grade generally means a lower dosage in the formula. If you are moving from a low to a high viscosity grade, start by reducing the dosage rather than keeping the same weight and expecting the same rheology.

The second point is that the surface-treated S grades disperse more readily in cold water than the standard grades, which matters for products that are hydrated in the factory rather than in the mixer on site.

Where to go next

Each grade has its own product page with the full specification and the viscosity figure at its stated concentration. The technical questions asked most often about these grades are answered in the product FAQ on each page.